Instek GDS-2204 200MHz Dual Channel DSO Oscilloscope TFT Color LCD

Longer Memory
• Advanced Trigger features
• 200MHz bandwidth
• Auto Frequency Counter
• Auto Setup Sequence
• Simultaneous Cursors
• 4-Channels
• 1GS/s Real-Time and 25GS/s equivalent-Time Sampling
• 25K Points Record Length Maximum
• 8ns Peak Detection
• Large 5.6-in TFT Color LCD Display
• Free 128 MB USB Storage Device
• 3-USB Ports; USB Host/Device: Support USB Printer and USB Flash disk. Use a USB thumb drive to store data, images, settings, and even do firmware updates via the USB.
• DC Battery Power Operation (Opt-2)
• 24 Automatic Measurements
• Trigger Modes: Video/Pulse Width/Event-Delay/Time-Delay
• FFT Analysis (Fast Fourier Transform Algorithms)
• Program Mode
• Go/No-Go Production Test Feature
• RS-232 Standard
• USB Host/Device Standard
• GPIB Interface (GDS-2000 Opt-1 IEEE-488.2 Factory Installed)
• Large 8 ×12 Divisions Waveform Display
• Ultra-bright Color TFT LCD display
• Store waveform raw data (CSV files)
• Capture screen image as BMP files
• Print waveform via USB printer
• Free Software

• SPECIFICATIONS Instek GDS-2204 Digital Storage Oscilloscope DSO 200MHz 4-Channels VERTICAL Channels 4 Bandwidth DC ~ 200MHz (-3dB) Rise Time 1.75ns Approx. Sensitivity 2mV/div ~ 5V/div (1-2-5 increments) Accuracy ±(3% x |Readout|+0.05 div x Volts/div+0.8mV) Input Coupling AC, DC & Ground Input Impedance 1MΩ±2%, ~16pF Polarity Normal & Invert Maximum Input 300V (DC+AC peak), CATII Waveform Signal Process + , - , FFT Offset Range 2mV/div ~ 20mV/div : ±0.5V 50mV/div ~ 200mV/div : ±5V 500mV/div ~ 2V/div : ±50V 5V/div : ±300V Bandwidth Limit 20MHz (-3dB) TRIGGER Sources CH1 , CH2 , CH3, CH4,Line Modes Auto-Level, Auto, Normal, Single, TV, Edge, Pulse Width, Time-delay, Event-delay Coupling AC , DC , LF rej. , HF rej. , Noise rej. Sensitivity DC ~ 25MHz : Approx. 0.5div or 5mV 25MHz ~ 200MHz : Approx. 1div or 10mV EXT TRIGGER Range ±15V Sensitivity DC ~ 30MHz : ~ 50mV ; 30M ~ 200MHz : ~100mV Input Impedance 1MΩ±2% , ~ 16pF Maximum Input 300V (DC AC peak) , CATII HORIZONTAL Range 1ns/div ~ 10s/div (1-2-5 increments); ROLL : 250ms/div ~ 10s/div Modes Main, Window, Window Zoom, Roll, Scan, X-Y Accuracy ±0.01% Pre-Trigger 20 div maximum Post-Trigger 1000 div X-Y MODE X-Axis Input Channel 1 Y-Axis Input Channel 2 Phase Shift ±3° at 100kHz SIGNAL ACQUISITION Real-Time Sample Rate 1GSa/s maximum Equivalent Sample Rate 25GSa/s maximum Vertical Resolution 8 Bits Record Length 25K Dots maximum Acquisition Mode Normal, Peak Detect, Average Peak Detection 10ns Average 2 , 4 , 8 , 16 , 32 , 64 , 128 , 256 CURSORS AND MEASUREMENT Voltage Measurement Vpp , Vamp , V avg , Vrms , Vhi , Vlo , Vmax , Vmin , Rise Preshoot/Overshoot , Fall Preshoot/Overshoot Time Measurement Freq , Period , Rise Time , Fall Time , Positive Width , Negative Width , Duty Cycle Delay Measurement Eight types of delay measurement Cursors Measurement Voltage difference between cursors (ΔV) Time difference between cursors (ΔT) Auto Counter Resolution : 6 digits Accuracy : ±2% Signal Source: All available trigger source except the Video trigger mode CONTROL PANEL FUNCTION Autoset Automatically adjusts Vertical VOLTS/DIV, Horizontal TIME/DIV, and Trigger level Save Setup Up to 20 sets of measurement conditions Save Waveform 24 sets of waveform DISPLAY TFT LCD Type 5.6 inch Display Resolution 234 (Vertically) x 320 (Horizontally) Dots Display Graticule 8 x 10 divisions ; 8 x 12 divisions (menu off) Display Brightness Adjustable INTERFACE Go/NoGo Output 5V Maximum/10mA TTL Open Collector Output RS-232 Interface DB 9-pin male DTE RS-232 interface GPIB Interface (Option) Fully programmable with IEEE 488.2 compliance USB USB Host/Device 2.0 full speed supported POWER SOURCE Line Voltage Range AC 100V ~ 240V , 48Hz ~ 63Hz , Auto selection Battery Power(Option) Battery : 10.8V Li-Ion battery pack Charge Time : 8 hours (Power ON) Operating Time : 3 hours , depending on operating condition MISCELLANEOUS Multi-Language Menu Available Online Help Available Time Clock Time and Date, Provide the Date/Time for saved data ACCESSORIES   User manual x 1 Power Cord x 1 GTP-060A-2 Probe(10:1/1:1) x 2 DIMENSIONS &WEIGHT     310(W) x 142 (H) x 254D mm Approx. 4.3kg Ordering Information BACK TO TOP Model Instek Digital Storage Oscilloscope Description Data Manual MSRP Sale Purchase GDS-2204 200MHz 4-Ch TFT LCD Monitor $2020.00 $1799.00 Buy Now GDS-2204GP GDS-2204 + Opt-1 = GDS-2204 with IEEE-488.2 $2320.00 $2088.00 Buy Now GDS-Opt-2 Battery Pack for GDS-2000 Series     $600.00 $540.00 Buy Now GRA-405 Rack Adapter for GDS-2000 Series     $250.00 $225.00 Buy Now GSC-005 Soft Carrying Case for GDS-2000 Series   $70.00 Buy Now OR Please Email ATEquip.com for Product Availability or a Price and Delivery Quotation. Thank you.   Instek GDS-2204 100MHz Digital Storage Scope GDS 2204 4-Channels GDS-2204