Fluke Hart Scientific 5606 & 5607 RTD Full Immersion PRTs Thermometers for Freezers, Autoclaves and Furnsces

Fluke Hart Scientific 5606 and 5607 PRT Thermometers are Designed to Perform "Full IMmersion in Extreme Environments

The Fluke Hart 5606 and 5607 Fully Immersionable PRTs are designed to perform in extreme environments where both the transition junction and the lead wires are required to withstand temperatures covering the entire operating range of the probe. (“Immersion” in this case simply means exposure to temperatures other than ambient and does not necessarily refer to the medium to which the PRT and its components are subjected.)

Hart 5606 & 5607 "Full Immerison" Thermometer Applications

Applications where “full immersion” of probe, transition junction, and lead wire is required can include calibration or validation of sensors used in laboratory or bio freezers, walk-in refrigerators, autoclaves, ovens, stability test chambers, furnaces or incubators. Other applications might include IQ/OQ/PQ qualification procedures, temperature mapping, or data logging in temperature controlled spaces or environmental chambers.

Fluke Hart 5606 Immersion PRT Thermometer Operates from –200°C to 160°C

Hart's 5606 PRT is just two inches (50 mm) in length with a sheath diameter of 1/8 inch (3.1 mm). Since the Hart 5606 can be fully immersed over its entire temperature range, you don’t have to worry about calculating minimum immersion depth—immerse the entire probe, transition junction, and lead wires, in either non-corrosive liquids or dry mediums ranging from –200 °C to 160 °C. The 100 Ohm precision sensing element (alpha = 0.00385) is specially constructed to prevent the ingress of moisture while achieving calibration accuracies as good as ± 0.05 °C. You get both accuracy and flexibility built into a small, durable package.

Harts' 5606 PRT Thermometer is Designed to Prevent Accuracy Degration via Moisture Contamination

The lead wires of the Hart 5606 PRT are made of single-conductor enameled copper wire which prevents moisture from wicking to the sensing element as it would if a more common, stranded lead wire were used. The diameter of the lead wire is no greater than 0.2 mm, making it easy to run lead wires through a freezer door to your readout or transmitter with effectively zero energy loss. Hart's 5606 PRT has been proven in common heat transfer fluids such as silicone oil, mineral oil, ethanol, and even liquid nitrogen with no degradation of the transition junction seal or lead wire insulation.

Fluke Hart 5607 Dry Medium PRT Thermometer Operates from 0°C to 450°C

Are you performing calibrations or verifying the accuracy of sensors used in ovens or furnaces? Hart's 5607 PRT Thermometer has been designed specifically for your application. Intended to be used in dry mediums only, the Fluke Hart 5607 PRT can be fully immersed over a temperature range of 0 °C to 450 °C. There isn't’t another PRT on the market that can be fully immersed over this range and remain as stable and accurate (± 0.055 °C). The lead wire of Hart's 5607 is shielded with braided stainless steel and connected to the transition junction with a strain relief spring. If you need longer lead wire than the standard length, call one of our Application Specialists at ATEquip today for a free quote. They can also help you determine which readout and probe termination are best suited for your application or help you select the right calibration for your probe.